Setup Guide TOPCON Apollo FSO - Single Liquid - Section Control
Doc. No. MAN0034 P 27 / 28
Revision. A Rev. Date 18/01/2022
Section Valve Tuning
For correct application of liquid in Constant Flow mode, section valves must be tuned
(or balanced) while the module is running using the following procedure.
1. Start the pump and perform a test using typical speed and application
rates. Ensure all sections are open.
2. Record indicated pressure on the section control module gauge. Taking a
photo on a smartphone is an easy way to do this.
RECORD PRESSURE
To Next Page
Loading...
