EasyManua.ls Logo

Topcon SL-3E - User Manual

Topcon SL-3E
45 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
INSTRUCTION MANUAL
SLIT LAMP
SL-3E

Table of Contents

Questions and Answers

  • L
    landrypaulAug 11, 2025
    What to do if my Topcon Outdoor Light has no illumination?
    • J
      Jessica CrawfordAug 12, 2025
      If your Topcon Outdoor Light isn't illuminating, first ensure the power cable is securely connected to the power outlet. Then, check if the power switch is turned ON. Also, make sure the plug on the lamphouse cover is firmly inserted. If these steps don't solve the issue, the bulb may have burned out, the bulb socket may be damaged, or the fuse may have blown, requiring you to replace the bulb, socket, or fuse, respectively.
  • R
    Ricky ReyesAug 18, 2025
    Why fixation bulb does not light on Topcon SL-3E?
    • J
      Jennifer MejiaAug 18, 2025
      If the fixation bulb on your Topcon Outdoor Light does not light up, ensure the connecting cable between the power source and chinrest is correctly and firmly inserted into the outlet. If the issue persists, the fixation target bulb may be burned out and needs replacement.
  • C
    collinslisaAug 25, 2025
    Why does the fuse keep blowing in my Topcon SL-3E?
    • S
      Stephanie MartinAug 25, 2025
      If the fuse blows in your Topcon Outdoor Light, it's likely due to using an incorrect type of fuse. Replace it with the type of fuse specified for the device.
  • L
    Laura McneilAug 29, 2025
    Why is the slit light too dim on my Topcon Outdoor Light?
    • J
      jsalazarAug 29, 2025
      If the slit light on your Topcon Outdoor Light is too dim, first ensure the bulb is correctly inserted. If the problem persists, check the filter lever position; it should not be at the ND position or any intermediate position. Set the filter lever to the correct position.
  • J
    Joshua WalterSep 4, 2025
    What to do if slit width closes by itself on Topcon Outdoor Light?
    • N
      Norma LoweSep 4, 2025
      If the slit width on your Topcon Outdoor Light closes by itself, the tension on the slit width control knob is likely too weak. Tighten the screw at the center of the slit width control knob to adjust the tension.

Topcon SL-3E Specifications

General IconGeneral
BrandTopcon
ModelSL-3E
CategoryOutdoor Light
LanguageEnglish