27
EN
3.15 SUN (Sunroof Initialization)
This function can turn the sunroof lock off, auto-close in case of rain, set the memory
function of sliding/tilting sunroof, set outside temperature threshold, etc.
3.16 EGR (EGR Adaption)
3.17 ODO (ODO Reset)
3.18 AIRBAG (Airbag Reset)
3.19 TRANSPORT (Transport Mode)
This function can learn the EGR (Exhaust Gas Recirculation) valve after it is cleaned or
replaced.
This function can copy and write the value of kilometers in the chip of the odometer so
that the odometer shows the actual mileage.
This function resets the airbag data to clear the airbag collision fault indicator, so that
the airbag computer in the vehicle can run normally.
This function can deactivate the transport mode so that the vehicle can function
normally.
It needs to be performed when the mileage is incorrect due to a damaged vehicle speed
sensor or odometer failure.
It needs to be performed when the airbag deploys, the corresponding fault code of
the collision data appears, the airbag indicator lights up, and the fault code cannot be
cleared.
3.12 SUS (Suspension Level Calibration)
3.13 AFS (Adaptive Front-Lighting System Reset)
This function is required to calibrate the level of the vehicle when the level sensor or
control module in the air suspension system is replaced or when the level of the vehicle
is incorrect.
This function enables you to initialize the adaptive headlamp system.
3.14 GEARBOX (A/T Learning)
This function helps complete the gearbox self-learning to improve gear shifting quality.
It needs to be performed when the gearbox is disassembled or repaired (after the car
battery is disconnected), which may lead to shift delay or shock problems.
It needs to be performed when the following functions are disabled in order to reduce
the power consumption: limiting the vehicle speed, not waking up the door opening
network, disabling the remote control key, etc.
To Next Page
Loading...
