3.3 Local time setting 17
NOTE
You can enjoy only standard definition video with the following
connectors:
• Composite video connector (VIDEO)
3.2.3 Audio mode
Basically, there are two audio sources as you can find two audio
sockets on the back panel of the digital receiver. You can enjoy
only one source or both of them in either stereo or mono. Set
the Sound Mode option as you desire.
Apart from this setting, you can change the sound mode with
the button. See § 5.2.4 for a detailed description.
The digital receiver can output two types of digital audio sig-
nals via the S/PDIF connector. One is an encoded signal, and
the other is a decoded signal. If your digital audio system does
not have a Dolby Digital decoder, you have to set the Dolby
Digital option to PCM. Otherwise, set it to Bitstream.
NOTE
If the service you are currently watching does not provide
Dolby digital, you cannot watch the programme with Dolby
sound even though you set the Dolby Digital option to Bit-
stream.
3.3 Local time setting
You should set your local time for timer events.
To Next Page
