100 mm
50 mm
3.3
70÷80
40
Door panel
40
45
Adapter
20
31
Rail
Fig.
10
70÷80
40
40
Adapter
20
31
70÷80 70÷80100÷150 100÷150
rail
Flaring
12
K200T-K280T
Materials of the fastening surface
Minimum thickness
IRON
ALUMINUM
REINFORCED CONCRETE
SOLID WOOD
PERFORATED CONCRETE
2 mm (with lesser thickness use threaded rivets)
3 mm (with lesser thickness use threaded rivets)
110 mm (with lesser thickness use chemical bolts)
INSTALLING THE ADAPTER AND RAIL
- Drill the door at the bottom and fasten the rail using flared self-tapping cylindrical screws diam. 4.8.
- Make sure the upper part of the panel crossbar is reinforced at the base (minimum thickness 3 mm);
@ The number of fastening holes will depend on the size and weight of the door.
- Mark the fastening points on the door using the adapter and rail as a templat;
- Drill the adapter and rail starting at about 70/80 mm from the end;
- Drill the door panel at the top and fasten the adapter using cylindrical M6 screws or cylindrical self-tapping d5.5 screws
depending on the type of material;
- Cut the adapter and rail to the measurement of the finished door width, removing another 2 mm from the jamb sider;
INSTRUCTIONS FOR INSTALLATION AND USE
EN
taking care not to damage the sliding base of the trolleys with the drill chuck. In case of damage, it is necessary to
replace the entire crossbar.
To Next Page
Loading...
Need help?
General
