3.11
Fig.
41
1
2
3
A
26
K200T-K280T
EN
INSTRUCTIONS FOR INSTALLATION AND USE
Fasten the lateral caps on the beam using 3 screws type TSP d3.5x9.5 for each cap, supplied in the hardware package.
- Drill symmetrical holes in the casing cover using a suitable drill with a Ø6.5 bit for aluminum, with the measurements
and position indicated in Fig.41 Ref.4
Fasten the casing to the beam using two more screws type TSP d3.5x9.5 (Fig.41 Ref.3).
Apply an antivibration felt strip every 300mm along the beam (Fig.41 Ref.1).
Fit the upper part of the casing in its housing on top of the beam, holding it in a tilted position at a 30° angle and insert it until
it is flush (Fig.41 Ref.2).
If it should not be possible to fasten the casing from the side, proceed as follows:
- Fasten the casing to the beam using the two screws type TCEI M5x10.
INSTALLING THE CASING
antivibration felt
M3,5x9,5 screws for
fastening casing
4
M5x10 screws for
fastening casing
Rating place and
“CE” marking
To Next Page
Loading...