2.1 INSTALLATION
2. Attach the short linear rail assembly to the outside of both the right front panel and the front lower panel with two sets of two M6 × 1.0 - 12
screws.
Figure 2-21: Right lower linear assembly attached to the outside of the enclosure's lower right side.
3. Repeat Steps 1 to 2 for the remaining three linear rails, with the linear rail mount's clamping screws face in the following directions:
l Up on the lower linear assemblies
l Down on the upper linear assemblies
Figure 2-22: Four linear assemblies attached to the enclosure.
Page 14
©Tormach® 2022
Specifications subject to change without notice.
tormach.com
TD10536: Installation Guide: 770M Enclosure (0522A)
To Next Page
Loading...
Need help?
General
