Tormach pathpilot Technical Document

Page 6
Tormach Inc.
1071 Uniek Drive, Waunakee, WI 53597
Phone: 608.849.8381 / Fax: 209.885.4534
©Tormach® 2014. All rights reserved.
Specicaons subject to change without noce.
TD10358_PathPilot_Controller_QSG_0216A
3. With the PathPilot controller powered on, click Update on the Status screen (see Figure 3).
4. Navigate to the (vX.X) le on the USB drive and click Update (see Figure 4).
5. Push red E-stop in when prompted and click OK.
6. To receive email nocaons when new versions of PathPilot are released, click Subscribe to receive
PathPilot news & updates on www.tormach.com/updates.
Restore DVD
A restoraon DVD is included with each controller. This DVD is used to restore the PathPilot controller to the
original factory sengs.
CAUTION! Data Loss: The DVD restore process completely erases the exisng operang system and all
les on the hard drive. Before installing, save important les to a USB drive or external hard drive. Failure to
do so will result in total data loss.
To install, load into the Opcal Drive (#3), and restart the controller. Click OK to all screen prompts. The
process takes approximately 10 minutes.
Figure 4 Figure 3

Tormach pathpilot Specifications

General

Brand	Tormach
Model	pathpilot
Category	Controller
Language	English