110
Important It is very easy to be misled by the burr and mistake the burr for
the line of light! Therefore you must remove the burr frequently during the
finishing of the grinding operation, so you clearly can watch the progress of a
gradually thinning the line of light.
Now sharpen again with a very
light pressure. Check frequently
to ensure that you do not over-
grind.
Stop sharpening immediately
when the line of light disap-
pears, which is a sign that the
edge is sharp.
Keep the tool in the jig and
hone and polish the inside on
the Profiled Leather Honing
Wheel LA-120.
Hone and polish the bevel. Set the Universal Support so that the
honing angle is the same as the grinding angle. Use the Marker
Method. Hone away the burr and polish the bevel to a mirror
finish.
Honing
It is easy to over-sharpen the
edge at the end of the process.
If this happens, you need to re-
shape the edge and start again
from the beginning.
Be careful when you grind at
the sides of the tool so that you
do not round off the corners.
Woodcarving tools should have
sharp corners!
To Next Page
Loading...
