32
THE SQUEEGEE DOES NOT DRY PROPERLY
1. Check that the squeegee rubbers are clean.
2. Check the adjustment of the height and the inclination of the squeegee (see section
“ADJUSTMENT OF THE SQUEEGEE” in “BEFORE USE”).
3. Check that the suction hose is correctly inserted in the proper location on the recovery tank or
that it is not clogged.
4. Clean the suction filter.
5. Replace the rubbers if worn out.
6. Check on the display that the starting signal of the suction motor is on.
7. Put the motor in standard mode if silenced.
8. Check that the suction motor cap is closed properly.
9. Check that the recovery tank is not full, thereby activating the float.
If the problem persists, please contact the authorized service center.
EXCESSIVE FOAM PRODUCTION
Check that low foam detergent has been used. Eventually add small quantities of anti foam liquid
into the recovery tank. Please consider
that a major foam production happens when the floor is slightly dirty.
In that situation please dilute further the detergent solution.
ALARM: TURN SPEED CONTROL SENSOR DEFECTIVE
The machine is provided with a sensor for the speed control when turning which, if damaged, will
show the following screen on the display together with the one of the activated function:
Contact an approved service center for maintenance
For operator safety, in case of damage during operation the speed will automatically decrease
until the component is restored.
STEERING
CONTROL
FAILURE
TROUBLESHOOTING
To Next Page
Loading...
Need help?
General