Tornado BD 14/4 User Manual (English)

Questions and Answers:

P
pmckenzieAug 1, 2025
Why is the squeegee on my Tornado Scrubber not picking up water well?
- D
  David LucasAug 1, 2025
  If the squeegee on your Tornado Scrubber isn't picking up water effectively, several factors could be at play. First, ensure the squeegee blades are clean. Next, check that the vacuum hose is correctly inserted. Also, clean the vacuum filter. If the blades are worn, replace them. Verify that the vacuum motor switch is on. Lastly, check the level in the recovery tank and empty it if necessary.
S
Stephen BeckAug 7, 2025
How to fix excessive foam production in my Tornado BD 14/4 Scrubber?
- C
  crystal53Aug 7, 2025
  To address excessive foam in your Tornado Scrubber, verify that a low foam detergent is being used. Additionally, try adding small quantities of anti foam liquid into the recovery tank. You may also need to dilute the detergent solution.
S
Samantha MoralesAug 13, 2025
What to do if the vacuum motor of my Tornado BD 14/4 does not work?
- R
  Robin ChanAug 13, 2025
  If the vacuum motor on your Tornado Scrubber isn't functioning, start by checking the charge level of the batteries by activating the main switch. Then, verify that the vacuum motor switch is on. Also, inspect the level in the recovery tank and empty it if needed.
S
Sandra BennettAug 19, 2025
Why is there insufficient water on the brush of my Tornado BD 14/4?
- L
  Lisa CastilloAug 19, 2025
  If there's not enough water on the brush of your Tornado Scrubber, check that the solenoid valve switch is on. Also, check the level of the liquid in the solution tank. Ensure that the solution flow adjuster, placed in front underneath the solution tank, is sufficiently open. Finally, press the brush activation levers.
M
mrobertsAug 26, 2025
How to troubleshoot if the brush motor of my Tornado BD 14/4 does not work?
- J
  Jessica BrownAug 26, 2025
  If the brush motor on your Tornado Scrubber isn't working, first check the charge level of the batteries by activating the main switch. Then, verify that the brush motor switch is on. Finally, ensure you press the brush activation levers.