Tornatech MPA - Motor Rotation and Alarm Checks

53
condition.
5
Set the Cut-Out and Cut-In settings by following the ViZiTouch documentation. You need
to be logged in to modify these settings. Verify the automatic start by dropping the system
pressure below the Cut-In setting.
6
Stop the motor by pressing the “STOP” membrane button. Note: the motor will only stop if
the system pressure is above the cut-out setting.
Tornatech Controller S/N: _________________________________________
Installation address: _________________________________________
_________________________________________
_________________________________________
Check list completed? _____________Yes _____________ No
Check list completed by: __________________________________________
Company: __________________________________________
Date: __________________________________________
Witnessed By: __________________________________________
Comments: ___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________