Toro 03681 - Setup; Inspection; Cutting Unit Kickstand

Setup
LooseParts
Usethechartbelowtoverifythatallpartshavebeenshipped.
ProcedureDescription
Qty.
Use
1
Cuttingunit
1Inspectthecuttingunit
2
Nopartsrequired
–
Usethekickstandwhentippingthe
cuttingunit
3
Nopartsrequired
–
Adjusttherearshield
4
Nopartsrequired
–
Mountthecounterweights
MediaandAdditionalParts
Description
Qty.
Use
Partscatalog1
Operator’sManual
1
CerticateofCompliance
1
Reviewthematerialandsaveinanappropriateplace:
Note:Determinetheleftandrightsidesofthemachine
fromthenormaloperatingposition.
1
Inspection
Partsneededforthisprocedure:
1
Cuttingunit
Procedure
Afterthecuttingunitisremovedfromthebox,inspect
thefollowing:
1.Checkeachendofthereelforgrease.Grease
shouldbevisiblyevidentinthereelbearingsand
internalsplinesofthereelshaft.
2.Ensurethatallnutsandboltsaresecurelytightened.
3.Makesurethecarrierframesuspensionoperates
freelyanddoesnotbindwhenmovedbackand
forth.
2
CuttingUnitKickstand
NoPartsRequired
Procedure
Wheneverthecuttingunithastobetippedtoexpose
thebedknife/reel,propuptherearofthecuttingunit
withthekickstand(suppliedwiththetractionunit)
tomakesurethenutsonthebackendofthebedbar
adjustingscrewsarenotrestingontheworksurface
(Figure3).
4