Toro 03708 - Adjusting the Support Rollers; Replacing the Warning Decal for CE Compliance; Installing the Hood Lock for CE Compliance

1
AdjustingtheSupportRollers
NoPartsRequired
Procedure
Dependingonwhatwidthcuttingunitsaretobeinstalled
onthetraction,adjustthesupportrollersasfollows:
•Ifusing27inchcuttingunits,therollersaretobe
installedintheuppermountingholesofsupport
assemblychannels(
Figure3).
•Ifusing32inchcuttingunits,therollersaretobe
installedinthelowermountingholesofsupport
assemblychannels(
Figure3).
g019541
1
2
3
Figure3
1.Supportassemblychannel3.Usethisholefor32inch
cuttingunits
2.Usethisholefor27inch
cuttingunits
2
ReplacingtheWarningDecal
forCECompliance
Partsneededforthisprocedure:
1Warningdecal
Procedure
OnmachinesrequiringCECompliance,afxthe
warningdecal,partno.120–1683overthewarningdecal
partno.120–1686.
3
InstallingtheHoodLockfor
CECompliance
Partsneededforthisprocedure:
1Hoodlockbracket
2Rivet
1
Screw,1/4x2inch
2
Flatwasher,1/4inch
1
Locknut,1/4inch
Procedure
1.Unhookthehoodlatchfromthehoodlatchbracket
(Figure4).
13