Decal Part: 138-1186
s_decal138-1186
Note: This machine complies with the industry standard stability test in the static lateral and
longitudinal tests with the maximum recommended slope indicated on the decal. Review the
instructions for operating the machine on slopes in the Operator’s Manual as well as the
conditions in which you would operate the machine to determine whether you can operate
the machine in the conditions on that day and at that site. Changes in the terrain can result
in a change in slope operation for the machine. If possible, keep the cutting units lowered to
the ground while operating the machine on slopes. Raising the cutting units while operating
on slopes can cause the machine to become unstable.
Warning—read the Operator’s Manual; all
operators should be trained before operating the
machine.
Warning—read the Operator’s Manual before
towing the machine.
Tipping hazard—do not turn sharply while
traveling fast; do not drive up or down slopes
greater than 16°; lower the cutting units when
driving down slopes; use a rollover protection
system and wear the seatbelt.
Warning—do not park the machine on slopes;
engage the parking brake, lower the cutting units,
shut off the engine, and remove the key before
leaving the machine.
Thrown object hazard—keep bystanders away.
Entanglement hazard, belt—stay away from
moving parts; keep all guards and shields in place.
3466-702A Page 2–14 Safety: Safety and Instructional Decals
To Next Page
Loading...
Need help?
General
