Toro 03721 - Adjusting the Rear Shield; Installing the Loose Parts

g191340
Figure3
1.Cuttingunitkickstand
3
AdjustingtheRearShield
NoPartsRequired
Procedure
Undermostconditions,thebestdispersionisattainedwhen
therearshieldisclosed(frontdischarge).Whenconditions
areheavyorwet,therearshieldmaybeopened.
Toopentherearshield(Figure4),loosentheboltsecuring
theshieldtotheleftsideplate,rotatetheshieldtotheopen
position,andtightenthebolt.
g191341
Figure4
1.Bolt2.Rearshield
4
InstallingtheLooseParts
Partsneededforthisprocedure:
1
Straightgreasetting
1
O-ring
Procedure
Thegreasettingmustbeinstalledonthereel-motorsideof
thecuttingunit.RefertoFigure5todeterminetheposition
ofthereelmotors.
g031275
Figure5
1.Cuttingunit15.Cuttingunit5
2.Cuttingunit2
6.Reelmotor
3.Cuttingunit3
7.Weight
4.Cuttingunit4
1.Removeanddiscardthesetscrewonthereel-motor
sideplate(Figure6).
4
G028640
g028640
Figure6
1.Capscrew(2)3.Greasetting
2.Setscrew4.Greasevent
2.Installthestraightgreasetting(Figure6).
3.Iftherearenocapscrewsonthereel-motorsideplate,
installthem(Figure6).
5