Toro 03721 - Setup; Inspect the Cutting Unit; Using the Kickstand When Tipping the Cutting Unit

Setup
LooseParts
Usethechartbelowtoverifythatallpartshavebeenshipped.
ProcedureDescription
Qty.
Use
1
Cuttingunit
1Inspectthecuttingunit.
2
Nopartsrequired
–
Usethekickstandwhentippingthe
cuttingunit.
3
Nopartsrequired
–
Adjusttherearshield.
Straightgreasetting
1
4
O-ring
1
Installthelooseparts.
5
Nopartsrequired
–
Adjustthecutting-unitsteering.
MediaandAdditionalParts
Description
Qty.
Use
Operator'sManual
1
Reviewthematerialsandkeeptheminanappropriate
place.
O-ring
1Usethesewhenmountingreelmotortocuttingunit.
Screws
2Usethesetomountreelmotortocuttingunit.
Note:Determinetheleftandrightsidesofthemachine
fromthenormaloperatingposition.
1
InspecttheCuttingUnit
Partsneededforthisprocedure:
1
Cuttingunit
Procedure
Afterthecuttingunitisremovedfromthebox,inspectthe
following:
1.Checkeachendofthereelforgrease.
2.Ensurethatallnutsandboltsaresecurelytightened.
3.Makesurethatthecarrierframesuspensionoperates
freelyanddoesnotbindwhenitismovedbackand
forth.
2
UsingtheKickstandWhen
TippingtheCuttingUnit
NoPartsRequired
Procedure
Wheneveryouhavetotipthecuttingunittoexposethe
bedknife/reel,propuptherearofthecuttingunitwiththe
kickstand(suppliedwiththetractionunit)tomakesurethat
thenutsonthebackendofthebedbar-adjustingscrewsare
notrestingontheworksurface(Figure3).
4