Overview of the InfoCenter Display (continued)
Setting the Auto Idle
1. In the Settings Menu, scroll down to Auto Idle.
2. Press the right button to change the auto idle time between Off, 8S, 10S, 15S, 20S, and
30S.
Setting the Blade Count
1. In the Settings Menu, scroll down to Blade Count.
2. Press the right button to change the blade count between 5, 8, or 11 blade reels.
Setting the Mow Speed
1. In the Settings Menu, scroll down to Mow Speed and press the right button.
2. Use the center and right button to select the appropriate mow speed set on the
mechanical mow-speed limiter on the traction pedal.
3. Press the left button to exit mow speed and save the setting.
Setting the Height of Cut (HOC)
1. In the Settings Menu, scroll down to HOC.
2. Press the right button to select HOC.
3. Use the center and right button to select the HOC setting. If the exact setting is not
displayed, select the nearest HOC setting from the list displayed.
4. Press the left button to exit HOC and save the setting.
Setting the Front and Rear Reel Speeds
Although the front and rear reel speeds are calculated by inputting the number of blades,
mow speed and HOC into the InfoCenter, the setting can be manually changed to
accommodate for different mowing conditions.
1. To change the Reel Speed Settings, scroll down to the F R
EEL RPM, R REEL RPM, or
both.
2. Press the right button to change the reel speed value. As you change the speed setting,
the display continues to show the calculated reel speed based on blade count, mow
speed and HOC, which was previously entered, but the new value is also displayed.
3466-702A Page 5–11 Operation: Before Operation
To Next Page
Loading...
Need help?
General
