Toro 03731 - Page 10

AdjustingtheRearGrassShield
Note:Whenoperatinginturfconditionswherethere
isexcessivedebrisorthatch,openthereardischarge
shieldtohelpallowthedebristodischargefromthe
reel.
1.Loosentheboltsonthepivotofthegrassshield
(Figure9).
g195550
Figure9
1.Pivotbolt2.Reargrassshield
2.Rotatethegrassshieldtothedesiredsetting,
andtightenthebolts(Figure9).
CAUTION
Throwndebriscouldcausepersonalinjury.
Donotopentherearshieldsothatitishigher
thanleveltoground.
AdjustingtheRollerScrapers
1.Loosentheangenutsthatsecuretheroller
scrapers(Figure10).
g313796
Figure10
1.Frontrollerscraper3.Transportroller
2.Cotterpin
4.Rearrollerscraper
2.Movethescraperrodsinorouttoattain0.0to
0.75mm(0.0to0.03inch)clearancebetween
thescraperandtheroller.
3.Ensurethatthescraperrodisparalleltothe
rollerandtothelevelsurface.
4.Tightentheangenutstolocktheadjustment.
AdjustingtheTransportRollers
Beforetheverticuttersareloweredtotheshopoor
orremovedfromthetractionunit,lowerthetransport
rollers(Figure10)toprotectthebladesfromhard
surfacecontact.
1.Removethecotterpinthatsecuresthetransport
rollerbrackettothesideplatepin.
2.Positionthetransportrollerasfollows:
•Lowertherollerbracketbeforetheverticutter
isloweredtotheshopoor.
•Raisetherollerbracketaftertheverticutteris
raisedtotheoperatingposition.
3.Securethetransportrollerbrackettotheside
platepinwiththecotterpin.
4.Repeattheprocedureontheoppositeendof
theverticutter.
AdjustingtheCutting-Unit
Steering
IncreasingtheSteeringfortheRearCutting
Units
Increasethesteeringontherearcuttingunitsby
removingthe2pivotspacers,hexsocketscrews,and
angelocknuts(Figure11)fromthecarrierframes
oftherearcuttingunits(cuttingunits2and3);refer
toFigure12.
g015978
Figure11
1.Hexsocketscrew
3.Carrierframe
2.Pivotspacer4.Flangelocknut
10