Toro 04019 - Installing the Cutting Unit to the Traction Unit

1
InstallingtheCuttingUnitto
theTractionUnit
Partsneededforthisprocedure:
2Bolt,M10x25mm
1.Placethemoweronitsdrumsonalevelsurface.
2.Lowerkickstand.Inserta1/4"dia.pinorequivalent
intoframeholeabovekickstandmountingbolt
(Figure4).
Figure4
1.1/4"Pin
3.Kickstand
2.Handle
3.Pushthecuttingunitunderthetractionunitand
thentothelefttoengagethetransmissioncoupling
(Figure5).
Figure5
1.Transmissioncoupling
4.Rotatethetractionunitframe(Figure6)forwarduntil
itengagesthecuttingunitpivotarms.
5.Securethetractionunitframetothecuttingunit
pivotarmswith(2)M10x25mmbolts(Figure6)
Figure6
1.Cuttingunitpivotarms
3.Bolts
2.Tractionunitframe
Note:Whentighteningthepivotarmmounting
fasteners,useanadjustableendwrenchtoholdthe
pivotarmparalleltothesideplate(Figure7)
Figure7
10