Toro 04019 - Cutting Unit Maintenance; Separating the Cutting Unit from the Traction Unit

CuttingUnitMaintenance
SeparatingtheCuttingUnit
fromtheTractionUnit
1.Placethemoweronitsdrumsonalevelsurface.
2.Lowerkickstand.Inserta1/4"dia.pinorequivalent
intoframeholeabovekickstandmountingbolt
(Figure51).
Figure51
1.1/4"Pin
3.Kickstand
2.Handle
3.Removegrassbasket.
4.Remove(2)boltssecuringcuttingunitpivotarmsto
tractionunitframetube(Figure52).
Figure52
1.Cuttingunitpivotarms
3.Bolts
2.Tractionunitframetube
5.Rotatepivotarmsforward(Figure52)andrest
tractionunitonrestrainedkickstand.
6.Pullcuttingunitforwardabout2inch(51mm)
andthentotherighttodisengagethetransmission
coupling(Figure53).
Figure53
1.Transmissioncoupling
7.Reverseproceduretoinstallcuttingunit.
Note:Whentighteningthepivotarmmounting
fasteners,useanadjustableendwrenchtoholdthe
pivotarmparalleltothesideplate(Figure54).
Figure54
AdjustingtheRearRoller
1.Adjusttherearrollerbracketstotheloworhigh
positiondependingondesiredheightofcutrange
(Figure55andFigure56).
•Positionthespacerabovethesideplatemounting
ange(factorysetting)whenheightofcut
settingsrangefrom1/16to1/4"(Fig.10).
31