Toro 07413LT - Checking the Brake-Fluid Level; Inspecting the Brakes

8.Verifythattheparkingbrakeisadjustedtothe
propertension;refertoCheckingtheParking
Brake(page43).
Note:Ifyoucannotadjusttheparkingbrake
totherequiredtension,thebrakepadsmay
bewornandneedtobereplace.Contactyour
authorizedTorodistributorforassistance.
CheckingtheBrake-Fluid
Level
ServiceInterval:BeforeeachuseordailyCheckthe
brake-uidlevelbeforethemotoris
rstused.
BrakeFluidType:DOT3
1.Parkthemachineonalevelsurface,engagethe
parkingbrake,shutoffthemachine,andremove
thekey.
2.Raisethehoodtogainaccesstothe
master-brakecylinderandreservoir(Figure56).
g034314
Figure56
1.Fillerneck(reservoir)3.DOT3brakeuid
2.Reservoircap
3.Lookattheoutlineoftheuidlevelatthesideof
thereservoir(Figure57).
Note:ThelevelshouldbeabovetheMinimum
line.
g002136
Figure57
1.Brake-uidreservoir
2.Minimumline
4.Iftheuidlevelislow,performthefollowing:
A.Cleantheareaaroundthereservoircap
andremovethecap(Figure56).
B.AddDOT3brakeuidtothereservoiruntil
theuidlevelisabovetheMinimumline
(Figure57).
Note:Donotoverllthereservoirwith
brakeuid.
C.Installthereservoircap(Figure56).
5.Closethehoodofthemachine.
InspectingtheBrakes
ServiceInterval:Every100hours
Important:Brakesareacriticalsafetycomponent
ofthemachine.Closelyinspectthematthe
recommendedserviceintervaltoensureoptimum
performanceandsafety.
•Inspectthebrakeliningforwearordamage.Ifthe
lining(brakepad)thicknessislessthan1.6mm
(1/16inch),replacethebrakelining.
•Inspectthebackingplateandothercomponents
forsignsofexcessivewearordeformation.
Replaceanydeformedcomponents.
•Checkthebrake-uidlevel;refertoCheckingthe
Brake-FluidLevel(page44).
44