Toro 22298 - Adjusting the Cutting Height; Starting the Engine; Shutting Off the Engine

AdjustingtheCuttingHeight
Youcanchangethecuttingheightateachwheelbyadjusting
acutting-heightlever.Cuttingheightsare25mm(1inch),38
mm(1-1/2inches),51mm(2inches),64mm(2-1/2inches),
76mm(3inches),89mm(3-1/2inches),102mm(4inches),
114mm(4-1/2inches).
DANGER
Adjustingthecutting-heightleverscouldbringyour
handsintocontactwithamovingbladeandresult
inseriousinjury.
•Shutofftheengineandwaitforallmovementto
stopbeforeadjustingthecuttingheight.
•Donotputyourngersunderthehousingwhen
adjustingthecuttingheight.
1.Pullthecutting-heightlevertowardthewheel(Figure
13)andmovethelevertothedesiredsetting.
Figure13
1.Rearcutting-heightlever(2)
2.Frontcutting-heightlever(2)
2.Releasethecutting-heightleverandseatitsecurelyin
thenotch.
3.Adjustallthewheelstothesamecutting-heightsetting.
StartingtheEngine
1.Connectthespark-plugwiretothesparkplug.
2.Openthefuelvalve(Figure14).
Figure14
1.Throttle-controllever2.Fuelvalve
3.Movethethrottle-controllever(Figure14)tothe
CHOKEposition.
Note:Donotusethechokewhentheengineiswarm.
4.Pullthestarterhandlelightlyuntilyoufeelresistance,
thenpullitsharply.
Note:Allowtheropetoreturnslowlytotherope
guideonthehandle.
5.Whentheenginestarts,movethethrottle-controllever
totheFASTposition.
ShuttingOfftheEngine
Releasetheblade-controlbarandmovethethrottle-control
lever(Figure14)totheSTOPposition.
Note:Closethefuelvalve(Figure14)ifyouwillnotbe
startingtheenginesoonafterward.
12