Toro 30193 - Height-Of-Cut Chart

Operation
26
Adjust Caster Position
1. Using the height-of-cut chart, adjust the caster
spacers to match with the axle hole selected
(Fig. 21).
2. Remove clevis pin, slide castor from support and
change spacers (Fig. 21).
3. Install castor in support and insert clevis pin
(Fig. 21).
m–3791
1
3
2
Figure 21
1. Clevis pin
2. 3/16” (5 mm) spacer
3. 1/2” (13 mm) spacer
Height-of-Cut Chart
Axle
No. of Spacers
Below Caster
Number of 1/4″ Blade Spacers Below Spindle
A
x
l
e
Position
1/2″ 3/16″ 4 3210
A 0 0 1” 1–1/4” 1–1/2” 1–3/4” 2”
A 0 1 1–1/8” 1–3/8” 1–5/8” 1–7/8” 2–1/8”
A 1 0 1–3/8” 1–5/8” 1–7/8” 2–1/8” 2–3/8”
B 0 1 1–3/8” 1–5/8” 1–7/8” 2–1/8” 2–3/8”
B 1 0 1–5/8” 1–7/8” 2–1/8” 2–3/8” 2–5/8”
B 1 1 1–3/4” 2” 2–1/4” 2–1/2” 2–3/4”
B 2 0 2” 2–1/4” 2–1/2” 2–3/4” 3”
C 1 1 1–7/8” 2–1/8” 2–3/8” 2–5/8” 2–7/8”
C 2 0 2–1/8” 2–3/8” 2–5/8” 2–7/8” 3–1/8”
C 2 1 2–1/4” 2–1/2” 2–3/4” 3” 3–1/4”
C 3 0 2–1/2” 2–3/4” 3” 3–1/4” 3–1/2”
D 2 1 2–3/8” 2–5/8” 2–7/8” 3–1/8” 3–3/8”
D 3 0 2–1/2” 2–3/4” 3” 3–1/4” 3–1/2”
D 3 1 2–3/4” 3” 3–1/4” 3–1/2” 3–3/4”
D 4 0 3” 3–1/4” 3–1/2” 3–3/4” 4”
E 3 1 2–7/8” 3–1/8” 3–3/8” 3–5/8” 3–7/8”
E 4 0 3–1/8” 3–3/8” 3–5/8” 3–7/8” 4–1/8”
E 4 1 3–1/4” 3–1/2” 3–3/4” 4” 4–1/4”