Toro 31950 - Mounting Tail Lights to Machine

g280317
Figure3
1.Taillightharness
3.Push-infastener(harness)
2.Taillight-supporttube
3
AssemblingtheTaillights
totheMachine
Partsneededforthisprocedure:
4
Capscrew(5/16x4inches)
4
Washer(5/16inch)
4
Flangelocknut(5/16inch)
Procedure
1.Aligntheholesinthetaillight-supporttubewith
theholesintheaxle-frametubeasshownin
Figure4.
g280310
g280311
Figure4
1.Lefttaillightassembly5.Flangelocknut(5/16inch)
2.Righttaillightassembly
6.Capscrew(5/16x4
inches)
3.Taillight-supporttube
7.Washer(5/16inch)
4.Axle-frametube
2.Securethetaillight-supporttubetothe
axle-frametube(Figure4)with2capscrews
(5/16x4inches),2washers(5/16inch),and2
angelocknuts(5/16inch).
3.Repeatsteps1and2forthetaillightattheother
sideofthemachine.
4.Routethelefttaillightwireharnessinboard,and
inserttheharnesspush-infastenerfurthestfrom
thelightintothe6mm(1/4inch)holeintheleft,
uppergussetplateoftheaxle-frametubeas
showninFigure5.
3