Toro 37805 - Engine Starting Procedures; Electric Start Procedure

To Next Page

To Previous Page

StartingtheEngine

ElectricStart

Note:Tousetheelectricstarter(electric-startmodelsonly),connectapowercordtotheplug-inrstandthen

toapoweroutlet.UseonlyaUL-listed,16-gaugeextensioncordrecommendedforoutdoorusethatisnot

longerthan15m(50ft).

WARNING

Theelectricalcordcanbecomedamaged,causingashockorre.

Thoroughlyinspecttheelectricalcordbeforeusingthemachine.Ifthecordisdamaged,do

notuseit.Replaceorrepairthedamagedcordimmediately.ContactanAuthorizedService

Dealerforassistance.

CAUTION

Ifyouleavethemachinepluggedintoapoweroutlet,someonecaninadvertentlystartthe

machineandinjurepeopleordamageproperty.

Unplugthepowercordwheneveryouarenotstartingthemachine.

g322955

Figure17

Main Page

Introduction1
Table of Contents2
Or Other Reproductive Harm2
Figure3
Safety3
General Safety3
Safety and Instructional Decals3
Setup5
Installing the Chute5
Unfolding the Upper Handle6
Installing the Traction-Control Linkage6
Installing the Chute-Control Rod7
Installing the Snow-Cleanout Tool7
Checking the Engine-Oil Level8
Checking and Adjusting the Tire Pressure8
Checking the Skids and Scraper8
Checking the Operation of the Traction Drive8
Product Overview9
Specifications10
Attachments/Accessories10
Operation10
Before Operation10
Before Operation Safety10
Freewheeling or Using the Self-Propel Drive11
Filling the Fuel Tank11
During Operation11
During Operation Safety11
Starting the Engine13
Shutting off the Engine14
Operating the Handwarmers14
Operating the Traction Drive15
Operating the Speed Selector15
Operating the Auger/Impeller Drive15
Operating the Quick Stick16
Clearing a Clogged Discharge Chute16
Operating Tips17
After Operation17
After Operation Safety17
Preventing Freeze-Up after Use17
Maintenance18
Recommended Maintenance Schedule(S)18
Maintenance Safety18
Preparing for Maintenance18
Checking the Engine-Oil Level19
Checking and Adjusting the Skids and Scraper19
Checking and Adjusting the Traction Cable20
Checking and Adjusting the Auger/Impeller Cable21
Checking the Auger-Gearbox-Oil Level21
Changing the Engine Oil22
Lubricating the Hex Shaft23
Replacing the Spark Plug23
Adjusting the Discharge-Chute Latch24
Replacing the Drive Belts24
Replacing the Headlight25
Storage25
Storage Safety25
Storing the Machine25
Removing the Machine from Storage26
Troubleshooting27

Toro 37805 - Engine Starting Procedures; Electric Start Procedure

Table of Contents

Related product manuals