16 Operation
Operation
Mixing the Fuel
This product is powered by a 2-cycle engine and requires
pre-mixing gasoline and 2-cycle oil. The oil mix should
be 50:1, using oil that meets or exceeds JASO-FC specifi-
cations.
Follow these steps to mix the fuel.
1. Obtain a clean container that is approved for use
with gasoline.
2. Mix the 2-cycle engine oil provided with unleaded
gasoline in the container, according to the instruc-
tions on the oil carton.
Important: This engine is certified to operate on
unleaded gasoline intended for automotive use with an
octane rating of 87 ([R + M] / 2) or higher. Do not use
automotive oil or 2-cycle outboard oil. Store the con-
tainer out of the reach of children.
+ =
Filling the Tank
Follow these steps to fill the tank.
1. Clean the surface around the fuel cap to prevent con-
tamination.
2. Loosen the fuel cap by turning it counterclockwise.
3. Pour the fuel mixture carefully into the tank.
4. Clean and inspect the gasket.
Note: Replace the fuel cap if the gasket is damaged.
5. Install the fuel cap and tighten it by turning it clock-
wise.
6. Wipe spilled fuel from the product.
7. Move at least 30 ft. (9 m) away before starting the
product.
Note: It is normal for the engine to emit smoke dur-
ing use.
DANGER:
Gasoline is extremely flammable and explosive. A
fire or explosion from gasoline will burn you and
others.
50:1 Gasoline to Oil Mixing Chart
Gasoline Oil
1/2 US gallon 1.3 oz.
1 US gallon 2.6 oz.
2 US gallons 5.2 oz.
1 liter 20 ml
2 liters 40 ml
3 liters 60 ml
4 liters 80 ml
5 liters 100 ml
WARNING:
Always stop the engine before filling the tank.
Never add fuel to a machine with a running or hot
engine. Move at least 30 ft. (9 m) away from the
refueling site before starting the engine. Do not
smoke while filling the tank.
WARNING:
Check for fuel leaks. If you find any leaks, correct
the problem before using the product.
To Next Page
Loading...