18
7. Install cap on filler neck.
2
1
3
M-4280
Figure 10
1. Cap
2. Baffle
3. Fluid level—full
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• If hydraulic fluid is injected into the skin it
must be surgically removed within a few hours
by a doctor familiar with this type of injury.
Gangrene may result if this is not done.
• Keep body and hands away from pin hole leaks
or nozzles that eject high pressure hydraulic
fluid.
• Use cardboard or paper to find hydraulic leaks.
• Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
• Make sure all hydraulic fluid hoses and lines
are in good condition and all hydraulic
connections and fittings are tight before
applying pressure to hydraulic system.
Warning
Greasing the Bearings
Make sure cutting unit spindles are full of grease
before engine is first started.
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
1. Grease the fittings on the three spindle bearings.
Grease until it comes out lower seals (Fig. 11).
1
M-5035
Figure 11
1. Spindles
Check Side Discharge Chute
Remove plastic tie holding side discharge chute up and
lower into place.
Check the Leveling of Mower
Deck
Check the level of the deck before the machine is first put
in use.
Refer to Mower Leveling and Compression Spring
Adjustment in the Maintenance section on page 44.
Check Engine Oil Level
Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to Checking Oil
Level, page 32.
To Next Page
Loading...
