Why Toro 74246TE Lawn Mower engine overheats?
If your Toro Lawn Mower engine overheats, consider these possible reasons: the engine load might be excessive, so reduce ground speed. Check the oil level in the crankcase and add oil if it's low. Also, make sure that cooling fins and air passages under the engine blower housing are free of obstructions; remove any you find.
Why is my Toro Riding mower starter not cranking?
If the starter on your Toro Riding mower isn't cranking, it could be due to several reasons. First, ensure the blade control (PTO) is disengaged. Next, confirm the parking brake is fully engaged and that you are seated properly on the seat. If these aren't the cause, check the battery; it might be dead and need charging. Also, inspect the electrical connections for any corrosion or looseness and replace the fuse if it's blown. If none of these steps work, the relay or switch may be defective, and you should contact an Authorized Service Dealer.
What to do if Toro Lawn Mower engine will not start?
If your Toro Lawn Mower engine won't start, starts hard, or fails to keep running, several factors could be the cause. First, ensure the fuel tank is filled with gasoline. Next, make sure the choke is on. Check if the air cleaner is dirty and clean or replace it if necessary. Also, ensure the spark plug wires are securely connected and that the spark plugs are in good condition and correctly gapped. Replace the fuel filter if it's dirty. If the issue persists, it could be due to dirt, water, or stale fuel in the fuel system, in which case you should contact an Authorized Service Dealer.
Why won't the starter crank on my Toro Mower?
If the starter on your Toro Mower isn't cranking, there could be several reasons: * The blade control (PTO) might be engaged. Disengage it. * The parking brake might not be set. Ensure it is set. * You might not be seated. Sit on the seat. * The battery could be dead. Charge it. * Electrical connections might be corroded or loose. Check and ensure good contact. * A fuse might be blown. Replace it.
What causes abnormal vibration in Toro Lawn Mower?
Abnormal vibration in your Toro Lawn Mower can stem from several issues: * Bent or unbalanced cutting blades—install new cutting blades. * Loose blade mounting bolt—tighten the bolt. * Loose engine mounting bolts—tighten these bolts. * Loose engine pulley, idler pulley, or blade pulley—tighten the appropriate pulley. For a damaged engine pulley or bent blade spindle, contact an Authorized Service Dealer.
How to fix abnormal vibration in my Toro Mower?
If you're experiencing abnormal vibration with your Toro Mower, check the following: * The cutting blades might be bent or unbalanced. Install new cutting blades. * The blade mounting bolt might be loose. Tighten it. * The engine mounting bolts might be loose. Tighten them. * A pulley (engine, idler, or blade) might be loose. Tighten the appropriate pulley.
What to do if Toro Mower blades do not rotate?
If your Toro Mower blades do not rotate, ensure that the mower belt is properly installed and check the adjusting plate, idler arm and spring, and belt guides for correct position. If the mower belt is worn, loose, or broken, install a new one.
How to fix uneven cutting height on my Toro Mower?
To address uneven cutting height with your Toro Mower: * Sharpen the blades if they are not sharp. * Replace bent cutting blades. * Level the mower from side to side and front to rear. * Adjust the gage wheel height if the anti-scalp roller is not set correctly. * Clean the underside of the mower if it's dirty. * Adjust the tire pressure if it is incorrect.
What to do if my Toro Riding mower does not drive?
If the Toro Riding mower does not drive, first check the hydro fluid level and add fluid to the reservoir if it's low. Also, verify that the tension spring is connected. If these steps don't resolve the issue, the traction belt may be worn, loose, or broken, or it might be off the pulley, in that case you should contact an Authorized Service Dealer.
How to fix a Toro Riding mower that won't start?
If the engine on your Toro Riding mower will not start, starts hard, or stalls frequently, try the following: Ensure the fuel tank is filled with gasoline. Move the choke lever to the 'on' position. Clean or replace the air cleaner element. Make sure the spark plug wires are securely installed on the spark plugs. Install new, correctly gapped spark plugs and replace the fuel filter if it's dirty. If the issue continues, there may be dirt, water, or stale fuel in the fuel system, and you should contact an Authorized Service Dealer.
General| Deck Material | Steel |
|---|---|
| Starter Type | Recoil |
| Mulching Capability | Yes |
| Bagging Capability | Yes |
| Side Discharge Capability | Yes |
| Engine Type | 4-Cycle |
| Cutting Width | 22 in / 56 cm |
| Weight | 80 lbs |
| Type | Walk-behind |
| Power Source | Gas |
| Wheel Size | 11 inches (rear) |
| Fuel Tank Capacity | 0.95 L |
To Next Page
