Toro 74246TE - Adjusting the Flow Baffle

5. Install the flang e n ut bushing, spacer , and bolt.
T or que to 40-45 ft-lb (54-61 N•m) ( Figure 18 ,
Figure 19 and Figure 20 ).
6. R e peat this adjustment on the other anti-scalp
rollers .
Figure 18
1. Anti-scalp roller 4. Flange Nut
2. Spacer
5. Bolt
3. Bushing
Figure 19
1. Anti-scalp roller 3. Flange Nut
2. Bushing 4. Bolt
Figure 20
1. Anti-scalp roller 4. Flange Nut
2. Spacer
5. Bolt
3. Bushing
Adjusting the Flow Bafe
T he mo w er disc harg e flo w can be adjusted for
different types of mo wing conditions . P osition the
cam loc ks and baffle to gi v e the best quality of cut.
1. Diseng ag e the PTO , mo v e the motion control
lev ers to the neutral loc k ed position and set
the parking brak e .
2. Stop the engine , remo v e the k ey , and w ait for
all mo ving par ts to stop before lea ving the
operating position.
3. T o adjust the cam loc ks , swing the lev er up to
loosen the cam loc k ( Figure 21 ).
4. Adjust the baffle and cam loc ks in the slots to
the desired disc harg e flo w .
5. Swing the lev er bac k o v er to tighten the baffle
and cam loc ks ( Figure 21 ).
6. If the cams do not loc k the baffle into place or
it is too tight, loosen the lev er and then rotate
the cam loc k. Adjust the cam loc k until the
desired loc king pressure is ac hiev ed.
23