EasyManua.ls Logo

Toro 74246TE - Servicing the Spark Plugs

Toro 74246TE
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6. W hen oil has drained completely , close the
drain v alv e .
Note: Dispose of the used oil at a recycling
center .
Figure 38
1. Oil drain valve 2. Oil drain hose
7. Slo wly pour appro ximately 80% of the
specified oil into the filler tube ( Figure 37 ).
8. Chec k the oil lev el; refer to Chec king the
Engine Oil Lev el.
9. Slo wly add the additional oil to bring it to the
Full mark.
Changing the Oil Filter
R e place the oil filter ev er y 200 operating hours or
ev er y other oil c hang e .
Note: Chang e the oil filter more frequently when
the operating conditions are extremely dusty or
sandy .
1. Drain the oil from the engine; refer to
Changing the Engine Oil.
2. R emo v e the old filter and wipe the filler
adapter g ask et surface ( Figure 39 ).
Figure 39
1. Oil lter 3. Adapter
2. Adapter gasket
3. P our new oil in through the center hole of the
filter . Fill it up to the bottom of the threads
inside .
4. Allo w the filter material to absorb the new oil
for 1 to 2 min utes .
5. Apply a thin coat of new oil to the r ubber
g ask et on the re placement filter ( Figure 39 ).
6. Install the re placement oil filter to the filter
adapter , tur n the oil filter cloc kwise until the
r ubber g ask et contacts the filter adapter , then
tighten the filter an additional 2/3 to 1 tur n
( Figure 39 ).
7. Fill the crankcase with the proper type of new
oil; refer to Ser vicing the Engine Oil.
8. R un the engine for about 3 min utes , stop the
engine , and c hec k for oil leaks around the oil
filter .
9. Chec k the engine oil lev el and add oil if needed.
Servicing the Spark Plugs
Chec k the spark plugs after ev er y 200 operating
hours .
Ensure that the air g ap betw een the center and
side electrodes is cor rect before installing the spark
plug . Use a spark plug wrenc h for remo ving and
installing the spark plugs and a g apping tool/feeler
g aug e to c hec k and adjust the air g ap . Install a new
spark plugs if necessar y .
T ype: Champion® R C12Y C , Champion®
Platin um 3071 or equi v alent
Air Gap: 0.030 inc h (0.76 mm)
35

Table of Contents

Related product manuals