Safety
T his mac hine meets or ex ceeds European
Standards in effect at the time of production.
Ho w ev er , improper use or maintenance b y the
operator or o wner can result in injur y . T o reduce
the potential for injur y , comply with these safety
instr uctions and alw a ys pa y attention to the
safety aler t symbol, whic h means CA UTION ,
W ARNING , or D ANGER-"personal safety
instr uction." F ailure to comply with the instr uction
ma y result in personal injur y or death.
Safe Operating Practices
T he follo wing instr uctions are from the CEN
standard EN 836:1997.
T his product is capable of amputating hands and
feet and thro wing objects . Alw a ys follo w all safety
instr uctions to a v oid serious injur y or death.
Training
• R ead the instr uctions carefully . Be familiar
with the controls and the proper use of the
equipment.
• Nev er allo w c hildren or people unfamiliar with
these instr uctions to use the la wnmo w er . Local
regulations can restrict the ag e of the operator .
• Nev er mo w while people , especially c hildren,
or pets are nearb y .
• K ee p in mind that the operator or user is
responsible for accidents or hazards occur ring
to other people or their proper ty .
• Do not car r y passeng ers .
• All dri v ers should seek and obtain professional
and practical instr uction. Suc h instr uction
should emphasize:
– the need for care and concentration when
w orking with ride-on mac hines;
– control of a ride-on mac hine sliding on a
slope will not be reg ained b y the application
of the control lev ers . T he main reasons for
loss of control are:
◊ insufficient wheel g rip , especially on
w et g rass;
◊ being dri v en too fast;
◊ inadequate braking;
◊ the type of mac hine is unsuitable for its
task;
◊ lac k of a w areness of the effect of
g round conditions , especially slopes;
◊ incor rect hitc hing and load distribution.
Preparation
• W hile mo wing, alw a ys w ear substantial
footw ear and long trousers . Do not operate
the equipment when barefoot or w earing open
sandals .
• T horoughly inspect the area where the
equipment is to be used and remo v e all objects
whic h ma y be thro wn b y the mac hine .
• W ar ning –Fuel is highly flammable .
– Store fuel in containers specifically designed
for this pur pose .
– R efuel outdoors only and do not smok e
while refuelling .
– Add fuel before star ting the engine . Nev er
remo v e the cap of the fuel tank or add fuel
while the engine is r unning or when the
engine is hot.
– If fuel is spilled, do not attempt to star t the
engine but mo v e the mac hine a w a y from
the area of spillag e and a v oid creating any
source of ignition until fuel v apors ha v e
dissipated.
– R e place all fuel tanks and container caps
securely .
• R e place faulty silencers .
• Before using, alw a ys visually inspect to see that
the blades , blade bolts and cutter assembly
are not w or n or damag ed. R e place w or n or
damag ed blades and bolts in sets to preser v e
balance .
• On m ulti-bladed mac hines , tak e care as rotating
one blade can cause other blades to rotate .
Operation
• Be aler t, slo w do wn and use caution when
making tur ns . Look behind and to the side
before c hanging directions .
• Do not operate the engine in a confined space
where dang erous carbon mono xide fumes can
collect.
4
To Next Page
Loading...
