Toro 74246TE - Servicing the Fuses; Drive System Maintenance; Adjusting the Tracking

Figure 44
4. Install the batter y in the mac hine and connect
the batter y cables; refer to Installing the
Batter y .
Note: Do not r un the mac hine with the
batter y disconnected, electrical damag e ma y
occur .
Servicing the Fuses
T he electrical system is protected b y fuses . It
requires no maintenance , ho w ev er , if a fuse blo ws
c hec k component/circuit for malfunction or shor t.
T he fuses are as follo ws:
• Main F1-30 amp , blade-type
• Alter nator F2-25 amp , blade-type
1. Unlatc h the seat and raise the seat to g ain
access to fuse holder ( Figure 45 ).
Figure 45
1. Main F1-30 amp
2. Alternator F2-25 amp
2. T o re place the fuses , pull out on the fuse to
remo v e it.
3. Install a new fuse ( Figure 45 ).
Drive System
Maintenance
Adjusting the Tracking
Note: Deter mine the left and right sides of the
mac hine from the nor mal operating position.
T he right hand pump has a knob for adjusting the
trac king .
Important: Adjust the handle neutral and
h y draulic pump neutral bef or e adjusting
the tracking . R efer to Adjusting the Handle
Neutral and Adjusting the Hy draulic Pump
Neutral.
1. Push both control lev ers forw ard the same
distance .
2. Chec k if the mac hine pulls to one side . If it
does , stop the mac hine and set the parking
brak e .
3. Unlatc h the seat and tip the seat up to access
the trac king knob .
4. Adjust the trac king as follo ws ( Figure 46 ):
• T o mak e the mac hine g o right, tur n the
knob to w ards the right side of the mac hine .
• T o mak e the mac hine g o left, tur n the knob
to w ards the left side of the mac hine .
39