Toro 74240 - Maintenance and Lubrication; Scheduled Maintenance Procedures

28
Maintenance
Recommended Maintenance Schedule
Maintenance Service
Interval
Maintenance Procedure
After First Use
• Change engine oil
• Check hydraulic fluid level
• Change hydraulic filter
Each Use
• Check engine oil level
• Check safety system
• Air cleaner filter minder
1
• Clean cooling systems
1
• Clean mower housing
Every 5 Hours
• Check cutting blades
• Grease blade spindle bearings
Every 25 Hours
• Check hydraulic fluid level
• Grease chassis
1
• Oil linkage bushings
1
• Check battery electrolyte
Every 50 Hours
• Check belts for wear/cracks
• Check tire pressure
• Service the spark arrester
Every 100 Hours
• Change engine oil
1
• Check hydraulic lines
Every 200 Hours
• Change engine oil filter
1
• Change hydraulic filter
• Service primary air cleaner
1
• Check spark plug(2)
• Replace low pressure fuel filter
Every 500 Hours or at
Storage
• Adjust castor pivot
• Adjust Wheel Hub Slotted Nut
Every 600 Hours or at
Storage
• Replace safety air cleaner
1
Every 1500 Hours or at
Storage
• Replace high pressure fuel filter
Before Storage
• Perform all maintenance procedures listed above before storage
• Drain gasoline
• Charge battery, disconnect cables
• Paint chipped surfaces
1
More often in dusty, dirty conditions
Important Refer to your engine operator’s manual for additional maintenance procedures.