Toro 74268 - Adjusting the Anti-Scalp Rollers

Figure21
1.Heightofcutlever
2.Pin
2.Toadjust,removethepinfromtheheight-of-cut
bracket(
Figure21).
3.Selectaholeintheheight-of-cutbracket
correspondingtotheheight-of-cutdesiredand,
insertthepin(
Figure21).
4.Movethelevertotheselectedheight.
UsingtheLiftAssistLever
Theliftassistleverisusedalongwiththeheight-of-cut
leverforraisingthemower.Thisallowsforeasier
raisingofthemower.
1.Placeyourfootontoliftassistlever.
2.Pressontheliftassistleverwhilepullinguponthe
height-of-cutlever(Figure22).
Figure22
1.LiftAssistLever
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheight-of-cut,itis
recommendedtoadjusttheheightoftheanti-scalp
rollers.
1.DisengagethePTO,movethemotioncontrol
leverstotheneutrallockedpositionandsetthe
parkingbrake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Afteradjustingtheheight-of-cut,adjusttherollers
byremovingtheangenut,bushing,spacer,and
bolt(
Figure23,Figure24andFigure25).
Note:Thetwomiddlerollerswillnothaveaspacer
(Figure24).
4.Selectaholesotheanti-scalprollerispositionedto
thenearestcorrespondingheight-of-cutdesired.
5.Installtheangenutbushing,spacer,andbolt.
Torqueto40-45ft-lb(54-61N-m)(
Figure23,
Figure24andFigure25).
6.Repeatthisadjustmentontheotheranti-scalp
rollers.
Figure23
1.Anti-scalproller4.FlangeNut
2.Spacer
5.Bolt
3.Bushing
Figure24
1.Anti-scalproller3.FlangeNut
2.Bushing4.Bolt
24