Toro 74268CP - Servicing the Fuses; Drive System Maintenance; Adjusting the Tracking

Figure51
1.PositiveBatteryPost
3.Red(+)ChargerLead
2.NegativeBatteryPost
4.Black(-)ChargerLead
ServicingtheFuses
Theelectricalsystemisprotectedbyfuses.Itrequires
nomaintenance,however,ifafuseblowscheck
component/circuitformalfunctionorshort.
Fuse:Main/Ignition-20amp,blade-type
Glowplug/Alternator-40amp,blade-type
1.Togainaccesstothemainfuse,unlatchtheseat
andtilttheseatforward.Togainaccesstothefan
andalternatorfuses,raisetheseatandtilttheengine
coverforward.
2.Toreplaceafuse,pulloutonthefusetoremoveit
(Figure52).
Figure52
1.Glowplug/Alternator-
40amp
2.Main/Ignition-20amp
DriveSystem
Maintenance
AdjustingtheTracking
Themachinehasaknobforadjustingthetracking
locatedundertheseat.
Important:Adjustthehandleneutralandhydraulic
pumpneutralbeforeadjustingthetracking.Refer
toAdjustingtheHandleNeutralinControlsSystem
Maintenance,page47andAdjustingtheHydraulic
PumpNeutralinHydraulicSystemMaintenance,
page48.
1.Pushbothcontrolleversforwardthesamedistance.
2.Checkifthemachinepullstooneside.Ifitdoes,
stopthemachineandsettheparkingbrake.
3.Unlatchtheseatandtilttheseatforwardtoaccess
thetrackingknob.
Note:Determinetheleftandrightsidesofthe
machinefromthenormaloperatingposition.
4.Tomakethemachinegoright,turntheknobtowards
therightsideofthemachine.RefertoFigure53.
5.Tomakethemachinegoleft,turntheknobtowards
theleftsideofthemachine.RefertoFigure53.
6.Repeatadjustmentuntilthetrackingiscorrect.
Figure53
1.Trackingknob4.Turnthiswaytotrackright
2.Hydraulictank
5.Turnthiswaytotrackleft
3.Hydraulicpumps
39