Toro 74408 - Adjusting the Anti-Scalp; Rollers; Positioning the Seat; Pushing the Machine by Hand

Adjusting the Anti-Scalp
Rollers
W henev er y ou c hang e the height-of-cut, adjust the
height of the anti-scalp rollers .
1. Diseng ag e the PTO , mo v e the motion control
lev ers to the neutral loc k ed position and set
the parking brak e .
2. Stop the engine , remo v e the k ey , and w ait for
all mo ving par ts to stop before lea ving the
operating position.
3. After adjusting the height-of-cut, adjust the
rollers b y remo ving the flang e n ut, bushing,
spacer , and bolt ( Figure 17 ).
4. Select a hole so the anti-scalp roller is
positioned to the nearest cor responding
height-of-cut desired.
5. Install the flang e n ut bushing, spacer , and bolt.
T or que to 40-45 ft-lb (54-61 N•m) ( Figure 17 ).
6. R e peat this adjustment on the other anti-scalp
rollers .
Figure 17
1. Bolt 4. Anti-scalp roller
2. Anti-scalp roller bracket
5. Spacer
3. Flange Nut 6. Bushing
Positioning the Seat
T he seat can mo v e forw ard and bac kw ard.
P osition the seat where y ou ha v e the best control
of the mac hine and are most comfor table .
1. Raise the seat and loosen the adjustment bolts
( Figure 18 ).
2. Mo v e the seat to the desired position and
tighten the bolts .
Figure 18
1. Adjustment bolts
2. Seat
Pushing the Machine by
Hand
Important: Al w ays push the machine
by hand. Nev er to w the machine because
dama ge may occur .
To Push the Machine
1. Diseng ag e the blade control switc h and mo v e
the control lev ers to the neutral loc k ed position
and apply the parking brak e .
2. Stop the engine , remo v e the k ey , and w ait for
all mo ving par ts to stop before lea ving the
operating position.
3. Pull the tw o b ypass lev ers rearw ard and push
them to the outside into the slot to loc k them
into place . ( Figure 19 ).
Note: Mak e sure both b ypass lev ers are
diseng ag ed before pushing the mac hine .
4. Diseng ag e the parking brak e to push the
mac hine .
19