Toro 74923 Z Master 6000 - Adjusting Height-of-Cut Pin

10.Fine-tunetheadjustmentnutonthefrontdecklift
assemblybyturningit(Figure91).
Note:Toincreasetheheight,turntheadjustmentnut
clockwise;todecrease,turncounterclockwise.
Note:Ifthefrontdecklinksdonothaveenough
adjustmenttoachieveaccuratecutheight,the
single-pointadjustmentcanbeutilizedtogainmore
adjustment.
g027344
1
2
2 1
3 4
Figure91
1.Adjustmentnut3.Reardeckadjustment
2.Jamnut4.Frontdeckadjustment
11.Toadjustthesingle-pointsystem,loosenthe2boltsat
thebottomoftheheight-of-cutplate(Figure92).
Figure92
1.Boltsatthebottomoftheheight-of-cutplate
12.Ifthedeckistoolow ,tightenthe
single-point-adjustmentboltbyrotatingitclockwise.If
thedeckistoohigh,loosenthesingle-point-adjustment
boltbyrotatingitcounterclockwise(Figure93).
Note:Loosenortightenthesingle-pointadjustment
boltenoughtomovetheheight-of-cutplatemounting
boltsatleast1/3thelengthoftheavailabletravelin
theirslots.Thisregainssomeupanddownadjustment
oneachofthe4decklinks.
g017036
Figure93
1.Single-pointadjustmentbolt
13.Tightenthe2boltsatthebottomoftheheight-of-cut
plate(Figure92).T
Note:Inmostconditions,thebackbladetipshould
beadjusted6.4mm(1/4inch)higherthanthefront.
14.Torquethe2boltsto37to45N∙m(27to33ft-lb).
58