What to do if my Toro 74960 overheats?
If your Toro Lawn Mower engine is overheating, it could be due to a few reasons. First, the engine load might be excessive, so try reducing the ground speed. Another cause could be a low oil level in the crankcase, so add oil. Finally, check the cooling fins and air passages above the engine for any obstructions and remove them.
What should I do if the oil-pressure light is on and the engine rpm is low on my Toro 74960 Lawn Mower?
If the oil-pressure light is on and the engine rpm is low on your Toro Lawn Mower, it means the engine-control unit has limited engine rpm, known as “limp” mode. Let the engine cool and check the engine-oil level. If the level is above the “add” line, contact an Authorized Toro Service Dealer.
What to do if my Toro Lawn Mower starter doesn't crank?
If the starter on your Toro Lawn Mower doesn't crank, try the following: Ensure the blade-control switch is disengaged, the parking brake is engaged, and the motion-control levers are in the NEUTRAL-LOCK position. Also, make sure you are sitting in the operator’s seat. If these aren't the issue, check the battery and charge if necessary. Inspect the electrical connections for corrosion or looseness and ensure good contact. Replace any blown fuses. If the problem persists, it could be a damaged relay or switch, in which case you should contact an Authorized Service Dealer.
What does it mean when the LED status light comes on in my Toro 74960?
If the LED status light comes on in your Toro Lawn Mower, it could indicate several issues. The engine may be too hot, so shut it off and let it cool. Old fuel in the fuel tank could also be the cause, so use new fuel. Ensure the fuel-shutoff valve is completely open and that the air cleaner is clean, replacing it if necessary. Check the battery charge and charge or replace the battery if needed. Also, check and replace any blown fuses. If these steps don't resolve the issue, it could be due to incorrect or dirty fuel filters, loose connections to the sensors electronic-control unit (ECU) and fuel injectors, or low voltage from the battery. In these cases, contact an Authorized Service Dealer. Make sure that you are using a good 12 V battery and that it is fully charged.
What to do if the blades on my Toro 74960 don't rotate?
If the blades on your Toro Lawn Mower aren't rotating, first inspect the mower deck belt for damage, wear, looseness, or breakage, and install a new deck belt if necessary. If the mower deck belt is off the pulley, reinstall it and check the idler pulley, idler arm, and spring for correct position and function. Check the pump drive belt for wear, looseness, or breakage, and adjust the belt tension or install a new belt. Finally, check the idler spring and replace it if it's broken or missing.
What does it mean if the oil-temperature light is on and the engine rpm is low on my Toro 74960 Lawn Mower?
If the oil-temperature light is on and the engine rpm is low on your Toro Lawn Mower, it indicates that the engine-control unit has limited engine rpm, known as “limp” mode. Check the engine-oil level. If the level is above the “add” line, contact an Authorized Toro Service Dealer.
What to do if the Malfunction-Indicator Light (MIL) comes on in my Toro 74960?
If the Malfunction-Indicator Light (MIL) comes on in your Toro Lawn Mower, turn the engine off and let it cool. You can also try using new gas, opening the fuel-shutoff valve, or ensuring that the air cleaner and precleaner are clean (replace if necessary). Also, charge or replace the battery. If problems persist, ensure that a good 12 volt battery is being used and is fully charged, check and replace any blown fuses, or contact an Authorized Service Dealer.
Why does the starter not crank on my Toro 74960 Lawn Mower?
If the starter on your Toro Lawn Mower does not crank, ensure that the blade control switch (PTO) is disengaged. Also, set the parking brake, ensure that the drive levers are in the neutral lock position, and sit on the seat. You may also need to charge the battery, check the electrical connections for good contact, or replace the fuse. If problems persist, contact an Authorized Service Dealer.
Why is my Toro 74960 not driving?
If your Toro Lawn Mower isn't driving, the bypass valves might not be closed tight, so tighten them. Alternatively, the pump belt might be worn, loose, or broken; in this case, change the belt. Another possibility is that the pump belt is off a pulley, so change the belt. The idler spring could also be broken or missing, so replace the spring. Lastly, the hydraulic fluid level might be low or too hot, so add hydraulic fluid to the reservoirs or let it cool down.
What to do if the LED status light comes on in my Toro 74960 Lawn Mower?
If the LED status light on your Toro Lawn Mower comes on, it could be due to several reasons. The engine might be too hot, in which case you should shut it off and let it cool. Old fuel in the tank could also be the culprit, so try using new fuel. Ensure the fuel-shutoff valve is completely open. Check and clean the air cleaner, replacing it if necessary. Also, make sure the battery is charged or replace it if needed. Finally, check and replace any blown fuses.
General| Brand | Toro |
|---|---|
| Model | 74960 |
| Category | Lawn Mower |
| Language | English |
To Next Page
