Why does my Toro 74946 pull left or right?
If your Toro Lawn Mower is pulling to the left or right even with the levers fully forward, it could be due to tracking issues or incorrect tire pressure. Adjust the tracking as needed and ensure the tire pressure in the drive tires is correct.
Why won't my Toro 74946 engine start, starts hard, or fails to keep running?
If your Toro Lawn Mower engine will not start, starts hard, or fails to keep running, fill the fuel tank, open the fuel shutoff valve and add oil to the crankcase. Ensure that the throttle control is midway between the “SLOW” and “FAST” positions. Also, replace the fuel filter, clean or replace the air cleaner element, check the seat switch indicator (replace the seat if needed), check the electrical connections for good contact (clean the connector terminals thoroughly with electrical contact cleaner, apply dielectric grease, and reconnect), clean, adjust, or replace the spark plug and check the spark plug wire connection. If problems persist, contact an Authorized Service Dealer.
What to do if my Toro 74946 engine loses power?
If your Toro Lawn Mower engine is losing power, consider the following: * Reduce the ground speed if the engine load is excessive. * Clean the air-cleaner element. * Add oil to the crankcase if the oil level is low. * Remove any obstructions from the cooling fins and air passages above the engine. * Clean or replace the fuel cap if the vent hole is plugged. * Replace the fuel filter if it is dirty.
Why don't the blades rotate on my Toro 74946?
If the blades on your Toro Lawn Mower aren't rotating, it could be due to: * A worn, loose, or broken mower deck belt; install a new deck belt. * The mower deck belt being off the pulley; install the mower deck pulley and check the idler pulley, idler arm, and spring for correct position and function. * A worn, loose, or broken pump drive belt; check the belt tension or install a new belt. * A broken or missing idler spring; replace the spring.
Why is my Toro 74946 Lawn Mower engine losing power?
If your Toro Lawn Mower engine is losing power, it could be due to several reasons. The engine load might be excessive, so try reducing the ground speed. A dirty air cleaner can also cause this, so clean the air-cleaner element. Check the oil level in the crankcase and add oil if it's low. Make sure the cooling fins and air passages above the engine are clear of obstructions. The vent hole in the fuel cap could be plugged, so clean or replace the fuel cap. A dirty fuel filter can also cause power loss, so replace it. For issues like dirt, water, or stale fuel in the fuel system, contact an Authorized Service Dealer.
Why is the malfunction indicator light (MIL) on my Toro 74946 on?
If the malfunction indicator light (MIL) on your Toro Lawn Mower comes on, there could be several reasons. The engine might be too hot, in which case you should turn it off and let it cool. Old gas in the tank can also trigger the light, so try using new gas. Ensure the fuel-shutoff valve is completely open. A dirty air cleaner can cause this issue, so clean or replace it as needed. Also, check the battery charge and replace the battery if necessary. If the problem persists, it could be due to incorrect or dirty fuel filters, loose connections to the sensors, low battery voltage, or a blown fuse. For fuel filters or sensor issues, contact an Authorized Service Dealer. Ensure you are using a good 12-volt battery and replace any blown fuses.
What to do if the oil-temperature light is on and the engine rpm is low on my Toro Lawn Mower?
If the oil-temperature light is on and the engine rpm is low on your Toro Lawn Mower, it may be because the engine-control unit has limited engine rpm, known as “limp” mode. Check the engine-oil level. If the level is above the “add” line, contact an Authorized Toro Service Dealer.
Why does the clutch not engage on my Toro 74946?
If the clutch does not engage on your Toro Lawn Mower, it could be due to: * A blown fuse; replace the fuse. * Low voltage supply at the clutch; check the coil resistance, battery charge, charging system, and wiring connections, and replace components if necessary. * A damaged coil; replace the clutch. * Inadequate current supply; repair or replace the clutch lead wire or electrical system. Clean the connector contacts. * The rotor/armature air gap being too large; remove the shim or replace the clutch.
Why is the malfunction-indicator light (MIL) on my Toro Lawn Mower on?
The malfunction-indicator light (MIL) on your Toro Lawn Mower might come on due to several reasons: * The engine may be too hot; if so, shut it off and let it cool. * There might be old fuel in the fuel tank; use new fuel instead. * The fuel-shutoff valve may not be completely open; open it fully. * The air cleaner could be dirty; ensure the air cleaner and precleaner are clean, replacing them if needed. * The battery may not be charged; charge or replace it. * There may be low voltage from the battery, so ensure you are using a good 12 V battery and that it is fully charged. * A fuse may be blown; check and replace any blown fuses.
What to do if my Toro Lawn Mower starter does not crank?
If the starter on your Toro Lawn Mower isn't cranking, try the following: * Ensure the blade-control switch (PTO) is disengaged. * Engage the parking brake. * Make sure the motion-control levers are in the NEUTRAL-LOCK position. * Sit on the seat. * Charge the battery, if it's dead. * Check the electrical connections for good contact and replace the fuse if it's blown.
General| Brand | Toro |
|---|---|
| Model | 74946 |
| Category | Lawn Mower |
| Language | English |
To Next Page
