Toro GrandStand 74568TE - Replacing the Grass Deflector

5.Checkthefront-to-rearpitchofthecuttingunit.
6.Ifthedimensionsarenotcorrect,adjustthefront
andrearnutsoneithersidetogetthecorrect
front-to-rearpitch(
Figure86).
G015246
Figure86
1.Adjustmentrods3.Frontnuts
2.Rearnuts
MatchingHeightofCut
1.Checkthereartirepressure.
2.Settheheight-of-cuttothe3inch(7.6cm)position.
RefertoAdjustingtheHeight-Of-CutinOperation.
3.Withthemachineonlevelsurface,positiononeblade
front-to-rear.MeasureatAandfromlevelsurfaceto
thecuttingedgeofthebladetips(
Figure87).
Figure87
1.Measurefromalevel
surface
2.MeasurebladeatpointA
4.Themeasurementshouldbe3inch(7.6cm).
5.Ifitdoesnotmeasurecorrectly,locatethe
height-of-cutrodontherightsideofthemachine
(Figure88).
6.Adjusttheadjustmentboltuntilthebladetipsmatch
3inches(7.6cm)(
Figure88).
g015336
1
2
Figure88
1.Height-of-cutrod
2.Adjustmentbolt
ReplacingtheGrassDeector
WARNING
Anuncovereddischargeopeningcouldallowthe
lawnmowertothrowobjectsintheoperator'sor
bystander'sdirectionandresultinseriousinjury.
Also,contactwiththebladecouldoccur.
Neveroperatethelawnmowerunlessyouinstalla
coverplate,amulchplate,grassdeectororbagger.
57