Toro GrandStand Mulching Kit - Installation; Loose Parts; Preparing the Mower; Removing the Existing Blades

Installation
LooseParts
Usethechartbelowtoverifythatallpartshavebeenshipped.
ProcedureDescription
Qty.
Use
1
Nopartsrequired
–
Preparethemower.
2
Nopartsrequired
–
Removetheexistingblades.
3
Nopartsrequired
–
Drillthemowerdeck.
Leftbafe(3holes)
1
Rightbafe(4holes)
1
Carriagebolt(3/8x1inch)
6
4
Flangelocknut(3/8inch)
6
Installthebafes.
Kickertting
2
Carriagebolt(3/8x1inch)
4
5
Flangelocknut(3/8inch)
4
Installthekickerttings.
6
Recyclerblades(soldseparately)
2Installtherecyclerblades.
7
Flange-headcapscrews6
Convertthedeckforrear-discharge
operation.
Note:Recyclerblades(soldseparately)arerequiredtoinstallthiskit;refertothePartsCatalogforyour
machine.
1
PreparingtheMower
NoPartsRequired
Procedure
Note:Determinetheleftandrightsidesofthe
machinefromthenormaloperatingposition.
1.Parkthemachineonalevelsurface;disengage
thecuttingunit(s)andlowerthecuttingunit;
engagetheparkingbrake;shutofftheengine
andremovethekey;andwaitforallmovement
tostop.
2.Thoroughlycleanthemowerdeck.Remove
alldebristoensurethatthebafestproperly
againstthemowerdeck.
3.Repairallbentordamagedareasofthemower
deckandreplaceanymissingordamagedparts.
2
RemovingtheExisting
Blades
NoPartsRequired
Procedure
1.Liftthemachinesothatyoucanaccessthe
bottomofthemowerdeck.
2.Removetheexistingbladesfromthespindles;
refertotheOperator’sManualforyourmachine.
Note:Savethebladesforusewhencuttinggrass
inreardischargemode.
Youwillusethebladeboltandwasherforinstalling
therecyclerbladesin6InstallingtheRecyclerBlades
(page6).
2