Toro Greensmaster 04052 - Installing the Transport Wheels; Parts Needed for Wheel Installation; Adjusting the Cutting Unit; Pre-adjustment Checks

3
InstallingtheTransport
Wheels
Partsneededforthisprocedure:
1
Wheelshaft,right
1
Wheelshaft,left
2
Transportwheels(obtainseparately)
Procedure
1.Pushthekickstanddownwithyourfootandpull
uponthehandletosupportthemoweronthekick
stand.
2.Apply#242Loctitetothethreadsofthewheel
shafts.
3.Threadtherightwheelshaftintothedrivepulleyon
therightsideofthemachine(Figure6).
Note:Therightwheelshafthaslefthandthreads.
Figure6
1.Rightwheelshaft
4.Torquetheshaftto65to75ft-lb(88to101N-m).
5.Slidethewheelontotheaxle(Figure7).
6.Pivotthewheellockingclipawayfromcenterof
thewheelallowingittoslidefartherontotheaxle
(Figure7).
Figure7
1.Lockingclip
7.Rotatewheelbackandforthuntilitslidescompletely
ontoaxleandlockingclipissecuredingrooveon
axleshaft.
8.Repeatprocedureonoppositesideofmachine.
9.Inatethetiresto12to15psi.(574to718Pa).
4
AdjustingtheCuttingUnit
NoPartsRequired
Procedure
Beforeoperatingthemachine,completethefollowing
adjustments:
•Levelthereardrumtothereel.
•Adjustthebedknifetothereel.
•Adjusttheheight-of-cut.
•Adjustthegrassshieldheight
•Adjustthecut-offbar.
RefertotheCuttingUnitMaintenancesectionin
Maintenanceforinstructionsonperformingthese
procedures.
12