EasyManua.ls Logo

Toro GREENSMASTER 3100 - Hydraulic System Troubleshooting

Toro GREENSMASTER 3100
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
38
2. No #1 or Reverse Traction
speed. Normal #2 speed.
Defective or missing disc seal
between the #3 or #4 valve
sections.
Poppet inside #4 spool stuck
open. Off seat.
Open traction relief cartridge in
the #4 spool section.
Remove the valve bank.
Replace the disc seal.
Remove the valve bank.
Repair the #4 spool section.
Remove the relief cartridge.
Repair or replace it.
CONDITION CAUSE CORRECTION
HYDRAULIC:
1. No ground speed increase in
#2 selection.
Maladjusted control lever.
Maladjusted rear camshaft.
Mow-lift linkage binding or
broken lift pivot spring.
•Wrong detent parts in #4
spool.
#2 or #3 spool relief valves
stuck open. (Reel drive RPM
will also be low on #1 or #3
cuffing unit).
Adjust. Refer to Traction
Switch Adjustment.
Adjust by moving right-hand
end of the rear camshaft
forward or left-hand end
rearward.
Lubricate or repair the
machine.
Remove valve bank & repair
#4 spool assembly.
Remove, and repair or replace
the relief cartridge.
2. Engine won’t start
Faulty ignition system
• No fuel
Defective starter system
Carburetor fuel solenoid
Repair as necessary
Check the fuel level. Add
gasoline to the tank.
Check connections, solenoid,
starter motor, ignition switch.
Check solenoid and wiring.
ENGINE:
1. Loss of power
Out of fuel
Clogged fuel line—debris in
the fuel tank
Clogged fuel filter
Low crankcase oil level
•Wrong oil in the crankcase
Carburetor fuel solenoid
Throttle cable set incorrectly
Choke closed
Plugged air cleaner element
Carburetor malfunction
Ignition malfunction
Cooling fins plugged with
debris.. Engine overheating.
Internal engine malfunction
Engine-pump coupling loose
Hydraulic system malfunction
•Re-fill the fuel tank
Clean the fuel tank. Use clean
gasoline.
Replace the filter
Add oil. Check the oil level
more often.
Replace with correct oil
Check solenoid and wiring
Repair as necessary
Readjust
Replace the element. Service
more often.
Repair as necessary.
Repair as necessary.
Clean fins. Repair the engine
as necessary.
Repair as necessary.
Repair or replace.
Refer to Hydraulic Trouble
Shooting, (See below).
Troubleshooting

Other manuals for Toro GREENSMASTER 3100

Related product manuals