9
Configuration: Tricycle vehicle with the front two
wheels providing drive and the rear wheel providing
steering. The operator sits in the center over the No. 1
cutting unit with the No. 2 & 3 cutting units in front
of the vehicle.
Power: 4-cycle gasoline engine, electric start, with
output of 13.4 kW @3,600 rpm. Maximum no-load
governed engine speed is 2,900 rpm.
Traction: All-hydraulic drive, consisting of multiple
stack pump valve, valve, and two orbital gear motors
to drive the front wheels.
Cutting Units: All-hydraulic drive, consisting of
three gear pump sections, three valve sections and
three gear motors that drive the reels.
Hydraulic Valve: Five spool sections: the first 3
spool sections control the lowering, mowing and lift
functions of the cutting units. The spools moved out
provide lowering and MOW operation; moved in they
provide LIFT operation. The number 4 spool section
controls the traction functions, N (Neutral), 1 (Mow),
and 2 (transport). The number 5 spool section
controls forward and reverse traction.
Tire Pressure :
• 55–83 kPa—front
• 55–103 kPa—rear
Brakes: 15 cm drum-type mechanical with rack and
pawl lock for parking.
Hydraulic Filter: 10-micron, cartridge type.
Hydraulic Oil Reservoir: 32.2 liter capacity with
internal baffle. Type fluid: Mobil 15M. Red dye is
added at the factory.
Gas Tank: 28.4 liter capacity.
Fuel Filter: In-line type.
Fuel Pump: Vacuum pulse type.
Seat Adjustment: 17.8 cm (forward and rearward).
Wheel Bearings:
Drive Wheels: Needle provided in wheel motors.
Rear Caster Wheels: Timken tapered roller
Electrical & Instrumentation: The engine contains a
18-amp alternator; the circuit is fused at 20 amps.
Instruments include ammeter and hour meter. An
accessory terminal is available at the leak detector test
switch if attachment of headlights is desired.
Battery: 12-Volt, lead acid, 32-amp. hour. Size:
Length—18.4cm, Width—12.4cm, height—15.2cm.
General Specifications:
Width of Cut: 149.9 cm
Wheel Tread: 123.3 cm
Wheel Base: 119 cm
Overall Length: 229 cm
Overall Width: 177 cm
Overall Height: 123 cm
Net Weight (Wet): 381 kg
Shipping Weight (In carton): 471 kg
Speeds:
1st —6.1 kmh
2nd—13 kmh
Rev.—3.1 kmh
Reels: 1,975 rpm (approximately)
Clip:
0.46 cm (11-Blade Cutting Unit)
0.64 cm (8-Blade Cutting Unit)
1.0 cm (5-Blade Cutting Unit)
Specifications and design subject to change
without notice
.
Specifications
To Next Page
Loading...
