Meter (Gerotor) End Disassembly
1. Clamp unit in vise, meter end up. Clamp lightly on
edges of mounting area. Use protective material on vise
jaws. Housing distortion could result if jaws are over-
tightened.
2. Remove 5/16" cap screws.
3. Remove end cap.
4. Remove seal from end cap.
5. Remove meter. Be careful not to drop star.
6. Remove seal from meter.
Figure 43
Figure 44
Figure 45
Repairs Page 4 - 62 Greensmaster
®
3100
To Next Page
Loading...
