7. Remove drive.
8. Remove spacer plate.
9. Remove seal from housing.
Control End Disassembly
10. Remove housing from vise. Place housing on a
clean soft cloth to protect surface finish. Use a thin blade
screwdriver to pry retaining ring from housing.
11. Rotate spool and sleeve until pin is horizontal. Push
spool and sleeve assembly forward with your thumbs
just far enough to free gland bushing from housing.
Remove bushing.
Figure 46
Figure 47
Figure 48
Greensmaster
®
3100 Page 4 - 63 Repairs
To Next Page
Loading...
