12. Remove quad-ring seal from seal gland bushing.
13. Use a thin blade screwdriver to pry dust seal from
seal gland bushing. Do not damage bushing.
14. Remove 2 bearing races and the needle thrust
bearing from spool and sleeve assembly.
15. Remove spool and sleeve assembly from 14 hole
end of housing.
IMPORTANT: Do not bind spool and sleeve in hous-
ing. Rotate spool and sleeve assembly slowly when
removing from housing.
16. Push pin from spool and sleeve assembly.
Figure 49
Figure 50
Figure 51
Repairs Page 4 - 64 Greensmaster
®
3100
To Next Page
Loading...
