Toro Groundsmaster 4000 Series - Page 17

InstallingtheSwitchPlatetothe
SteeringColumn
1.Aligntheswitchplatetotherearwardsideorthe
steeringcolumn(Figure37).
g350762
Figure36
1.Carriagebolt(1/4x2
inches)
2.Bracketmount
2.Attheupper6.4mm(1/4inch)holes,assemble
2carriageboltsbolt(1/4x2inches)throughthe
switchplateandtheotherbracketmount(Figure
36).
3.Assemblethefusemountplatetotheupper
bracketmountandcarriagebolts(Figure37)
with2angelocknuts(1/4inch).
g350772
Figure37
1.Bracketmount4.Fusemountplate
2.Carriagebolt(1/4x2
inches)
5.Flangelocknut(1/4inch)
3.Switchmount
4.Atthelower6.4mm(1/4inch)holes,assemble
2carriageboltsbolt(1/4x2inches)throughthe
switchplate,bracketmount,andfusemount
plate(Figure37)with2carriagebolts(1/4x2
inches)and2angelocknuts(1/4inch).
5.Aligntheswitchplatetotheoperator’sseat,and
tightenthe4angelocknuts.
ConnectingtheConsoleHarness
totheSwitches
1.Plugthe8-socketconnectorofthecontrol
harnesslabeledHAZARDSWITCHintothe8-pin
connectoroftherockerswitch(Figure38).
g350776
Figure38
1.8-pinconnector(rocker
switch)
2.8-socketconnector
(labeledHAZARD
SWITCH—console
harness)
17