Toro Groundsmaster 4000 Series - Page 25

AssemblingtheTaillights
1.Alignthetaillighttothelighthousingwiththe
yellowlenspositionedasshowninFigure58.
g350575
Figure58
1.Yellowlens(taillight)4.Phillips-headscrew(#10x
1-1/4inches)
2.Redlens(taillight)5.Clipnut(#10)
3.4-socketconnector
(taillightharness)
2.Plugthe4-socketconnectoroftheharnessinto
the4-pinconnectorofthetaillight(Figure58).
3.Assemblethetaillightintothelighthousing,and
securethelighttothehousing(Figure58)with2
Phillips-headscrews(#10x1-1/4inches).
4.Repeatsteps1through3fortheothertaillight
andlighthousing.
5.Installapivotbrackettothelight-housingmount
(Figure59)with3capscrews(1/4x3/4inch)
andlocknuts(1/4inch).
g351422
Figure59
1.Capscrew(1/4x3/4inch)
3.Pivotbracket
2.Light-housingmount
4.Locknut(1/4inch)
6.Installthemountcovertothelight-housing
mountwith4push-infasteners(Figure60).
g350666
Figure60
1.Push-infasteners
3.Light-housingmount
2.Mountcover
7.Repeatsteps5and6fortheothermountcover
andlightassembly.
InstallingthePivotMount
1.Attheleftsideofthebumper,removethe2
capscrews(1/2x1-1/4inches),2washers(1/2
inch),and2angelocknuts(1/2inch)securing
thebumpertotheleftframerail(Figure58).
25